Norwood Stage 1
BaselineLittle to no recession along the anterior hairline border or temples. The frontal line sits relatively flat above the brow crease, and the crown is completely full.
Not sure whether your hairline is Stage 1, a mature Stage 2, or Stage 3 temple recession? Compare every stage in the dual-view chart below, or measure your hairline proportions in a front-facing photo.
Start with your hair pulled back and the camera at eye level. Place or adjust the 3 hairline pins and select your crown state to combine frontal and vertex patterns.
The Hamilton-Norwood classification (Norwood 1975, surveyed across 1,000 adult men) maps patterned hair loss by combining two zones: the frontal-temporal hairline and the vertex (crown).
Little to no recession along the anterior hairline border or temples. The frontal line sits relatively flat above the brow crease, and the crown is completely full.
Shallow, symmetrical triangular indentation at both frontotemporal corners. Typically stops 1.5 to 2 cm above the highest forehead wrinkle (Rassman 2013) without vertex thinning.
Deeper, clearly visible frontotemporal recession forming an M, U, or V outline. The recessed corners sit bare or sparsely covered while the vertex remains intact.
Frontal recession stays near Stage 2 or early Stage 3, while an independent circular thinning spot appears at the vertex (crown), separated by a solid bridge of hair.
More pronounced frontal and temporal recession than Stage 3, paired with a distinct sparse or bare area on the crown. A moderately dense band of hair still bridges the mid-scalp.
The vertex and frontotemporal zones enlarge, and the band of hair separating them across the top of the scalp becomes narrower and noticeably sparser.
The mid-scalp bridge disappears as the frontal-temporal and vertex areas merge into one continuous zone, leaving hair along the sides and back.
The most extensive pattern on the scale. A narrow horseshoe-shaped band of hair remains low above the ears and across the occipital scalp at the back.
Described by Norwood (1975) as a less common variant: the entire frontal border moves backward uniformly without leaving a central forelock island or developing a separate vertex spot.
These dual-view diagrams illustrate characteristic outlines from Norwood (1975). A single front photo only shows the left column of each card; always check the crown before choosing Stage 3 Vertex or Stage 4.
You do not need a photo tool to run a basic geometry check. Stand in even lighting with a hand mirror and check three landmarks in order.
1.Raise your eyebrows to find the permanent top wrinkle
Look straight into a mirror and lift your brows high. The highest horizontal crease marks where the frontalis muscle ends—the juvenile hairline baseline. In adult men, a normal mature hairline commonly sits 1.5 to 2 cm above that crease at the temples (Rassman 2013).
2.Compare temple depth above the outer eye corner
Trace an imaginary vertical line straight up from your outer eye corner (lateral canthus) through the outer brow peak to your temple hairline. Compare how far that corner sits above the center of your hairline and whether the left and right sides match.
3.Inspect the vertex (crown) with a second mirror
Stand with your back to a bathroom mirror and hold a hand mirror or phone camera above the back of your head. A normal hair whorl shows a small skin pivot where strands spiral outward; a widening circular patch of visible scalp points toward vertex involvement.
To track whether a hairline is stable or moving over time, repeat this check under the same bathroom lighting every 3 to 6 months rather than comparing photos taken at different camera angles.
The single most common question on the Norwood Scale is where a normal adult mature hairline (Stage 2) ends and true M-shaped temple recession (Stage 3) begins.
Between ages 17 and 29, many men lose the flat juvenile edge and shift 1.5 to 2 cm higher at the temples (Rassman 2013). The corner angle stays shallow, hair along the border remains normal in caliber, and the vertex stays full.
Tool convention: Temple Recession Index 0.06 – 0.16
Temple indentation extends well past the maturation band into a pronounced M, V, or U curve. The vertical drop from the temple corner down to the central forelock tip exceeds 0.16 of midface height in 2D frontal projection.
Tool convention: Temple Recession Index > 0.16
A person can have a Stage 2 frontal hairline in a mirror selfie while developing early thinning on the crown (Norwood 3 Vertex). Because a front-facing photo cannot see behind the mid-scalp curve, the photo ruler grades your frontal hairline directly and includes an optional crown modifier if your vertex is also thinning.
MediaPipe's 478-point face mesh tracks facial skin landmarks, not hair follicles. Instead of guessing a stage from a black-box classifier, this tool levels head tilt and measures the 3 hairline pins against your midface height.
Project(Glabella 8 − Center Pin C, v) ÷ Project(Subnasale 2 − Glabella 8, v)
Measures central upper-third height relative to midface height (glabella to subnasale) along the roll-leveled vertical axis. In classical facial anthropometry (Farkas 1985), balanced facial thirds sit near 1.0.
Mean(max(0, Left Temple Height − Center Height), max(0, Right Temple Height − Center Height)) ÷ Midface Height
Quantifies how much higher the left and right temple corners sit above the central hairline peak, normalized by midface height. A flat hairline reads near 0.00; deeper M-shaped corners produce higher values.
|Left Temple Height − Right Temple Height| ÷ Midface Height × 100
Compares the vertical height of the two temple pins after leveling head roll. Uneven recession is common; a difference above 5% of midface height is flagged so you can check whether your head was turned.
In this tool's 2D coordinate conventions, a Temple Recession Index below 0.06 is labeled flat (Stage 1 contour), 0.06 to 0.16 is labeled shallow temple indentation (Stage 2 mature contour), and above 0.16 is labeled deep temple recession (Stage 3 contour).
A Forehead-to-Midface Ratio up to 1.05 reflects a typical central third; above 1.20 with a flat temple index (< 0.06) indicates a naturally high forehead rather than M-shaped recession, whereas above 1.20 with mild corner lift (0.06–0.10) maps to the Type A uniform frontal variant. Temple asymmetry above 5% is highlighted.
Why camera distance matters: Ward et al. (2018, JAMA Facial Plastic Surgery) demonstrated that a 12-inch (30 cm) selfie distorts facial proportions by roughly 30% compared with a standard 5-foot portrait. Tilting the phone slightly above eye level also foreshortens the midface and makes the forehead look taller.
Expose the hairline root
Use a headband or your hand to pull bangs and side strands back so the transition from forehead skin to hair roots is clearly visible at the center and both temples.
Keep the lens at eye level
Hold the camera straight in front of your eyes with your chin level. High-angle selfies exaggerate forehead height and temple depth.
Step back or use 2× zoom
Hold the phone at full arm's length or have someone take the photo from 1.5 meters away using a 2× portrait lens to minimize wide-angle perspective distortion.
Optional crown modifier
A front photo grades Stages 1–3 and Type A directly from your hairline. If your crown (vertex) is also thinning, toggle the crown modifier on the result card.
Central forehead height can stay nearly identical while the Temple Recession Index separates a shallow mature corner from a deeper M-shaped outline.

Central hairline sits at a 1.16 ratio with the midface, while both temples rise moderately above the center (Temple Index 0.08, left-right asymmetry 4.0%).

Central forelock height remains identical at 1.16, but the temple corners recede past 0.16 of midface height in 2D projection (Temple Index 0.21, left-right asymmetry 2.0%).
These two examples illustrate how separating central forehead height from temple depth prevents a naturally high forehead from being misread as Stage 3 temple recession.
Method comparison
Each method answers a different question. A 2D photo ruler measures macroscopic hairline geometry, while clinical trichoscopy examines microscopic hair shaft diameter.
The classification stages, anthropometric baselines, and perspective notes on this page draw from the peer-reviewed studies and clinical guides below.
Pull your front hair back, check the 3 draggable hairline pins against your midface height, and compare your reading with the Stages 1–7 chart.
Measure My Hairline